Beisler 100-54 - Manual (Page 14)

1-12
Change pocket length; press F3 and enter the new value for the
length to be sewed; when producing with flap, this sets the
photo cell security length, too; e.g. security length 140 mm
allows the sewing of a flap length between 130 and 150 mm;
when producing flaps it is possible to disable the security length
by entering 999 here.
Sewing-over at seam start and end (only valid when sewing with
flap); press once to set the sewing-over at seam start, twice to
set it at seam end; enter the new value using the ten key pad
Seam start: the smaller the set value, the more the flap will be
sewed over; seam end: the bigger the set value, the more the
flap will be sewed over
Pick needle thread manually; after the first pressing, the main
clamp drives to end position, with the second pressing the
needle thread catcher will be enabled; it remains enabled, until
the key is released
Push vylene forward manually (option); after changing the
vylene roll, the vylene will be cut with a key pressure and then
be pushed in position (only available if vylene mode is enabled)
Pick up piping, with this function the piping strip can be picked
up manually
Reset key; use this key to reset the program sequence step by
step; sets the clamp into starting position
4.1.1.6 Function keys – upper occupation
The function keys are double occupied. Press F1 to switch to the upper key
occupation. The icons will be displayed in the lower line.
switches back to the lower key occupation
Switch middle knife on/off; the knife is switched off, until it will be
switched on here; together with the middle knife, the mitre knife
is switched off
Switch mitre knife on/off; it remains switched off, until it will be
switched on here
Switch stacker on/off; it remains switched off until it will be
switched on here
without function here
Sets counter to zero
Manual spooling; the sewing head runs with low revs, after a
second key press, it stops in the upper needle position
Attention
At machines with insertion station, the station must be swung out first (see
chapter 4.1.10); in any case, both threads must be removed from the needles
and the spools from the pickers.