Beisler 100-54 - Manual (Page 35)

2-13
Both flap clamps switched on:
00: Insertion position
with foot pedal pressure
with 2
nd foot pedal pressure
01: Insertion position
with foot pedal pressure
02: Insertion position
automatic with folding slide
with foot pedal pressure
03: like 02
04: like 00
05: like 01
06: Insertion position
with foot pedal pressure
07: like 06
3.3.2 Working WITHOUT automatic clamp push-back
Seam parameter 24 INTERMEDIATE STOP SELECTION + POS.
This parameter allows to define the positioning of the main clamp after
stacking.
Seam parameter 24 = 0 cm.
This setting causes the main clamp to wait on the mitre knife position, until
the foot pedal seam process is pressed.
3.3.3 Working WITH automatic clamp push back
Seam parameter 24 INTERMEDIATE STOP SELECTION + POS.
Seam parameter 24 = 01 cm
With this setting the main clamp will be driven to the insertion position after
stacking. Pressing the foot pedal seam process closes the main clamp.
3.3.4 Working with INTERMEDIATE STOP of the main clamp
Seam parameter 24 = 20 cm
With this setting the main clamp will be driven until 20 cm before the insertion
position after stacking. Press the foot pedal seam process to drive the main
clamp to the insertion position.
If a different intermediate position of the main clamp is required, it can be
achieved by changing the SP 24. The higher the value the larger is the
distance between intermediate and insertion position.
3.3.5 Working with automatic PICK UP PART using the main clamp
Seam parameter 25 = PICK UP PART + POS.
Seam parameter 25 = 00 cm
Pick up part using the main clamp is disabled.
Seam parameter 25 = 01 cm
Pick up part using the main clamp until the insertion position.
The main clamps will be lifted after mitre cutting and SP 23 (duration final
roller) is carried out. The final roller pulls the work piece a little out of the
open main clamp. Now the main clamp is lowered after the time of basic
parameter 28 and drives with the work piece to the insertion position.
Seam parameter 25 = 01 cm