Beisler 100-54 - Manual (Page 52)

2-30
5.5.2.6 Final roller
1. Press the P-key.
2. Press the F6-key.
3. Press the F3-key.
4. Press the F6-key.
Enter a value between 01 ... 99 to check the speed of the final roller. Press
the ENT-key to switch off the motor again.
Press the P-key to terminate this function.
5.5.3 Service Code
Here two codes are contained, whith which all or only a part of the machine
data can be locked.
5.5.3.1 Machine Code
This is required to copy seam parameters, basic parameters or seam
programs and to select a part of the diagnostic programs.
The code number is ‘50190’. If this code is disabled due to safety reasons,
‘00000’ must be entered.
5.5.3.2 Safety Code
This code is required for the execution of most of the diagnostic functions. It
can be ordered in written form giving the machine number from the service
department of the company Beisler.
5.6 Preset sewing programs
The following shows the factory-set structure of the seams in the memory
buffer:
Seam-No. Seam
01 ... 09 Jacket outside pocket; with/without flap
10 ... 19 Jacket outside pocket; slanted pocket / slanted flap
20 ... 29 Inside pocket; lining pocket with pelon
30 ... 39 Pants pocket; pants front/back pocket with/without flap
40 ... 49 Pockets with zipper
The following shows the factory-set occupation of several memory locations
with seams:
Memory loc. Seam
M01 01 Flap pocket; jacket right panel
02 Flap pocket; jacket left panel
03 Welt pocket; jacket right panel
04 Welt pocket; jacket left panel
M02 10 Slanted pocket with flap; right panel
11 Slanted pocket with flap; left panel
12 Slanted welt pocket; right panel
13 Slanted welt pocket; left panel
M03 20 Jacket inside pocket with pelon; pocket length 100 mm
21 Jacket inside pocket with pelon; pocket length 100 mm
22 Jacket inside pocket with pelon; pocket length 150 mm
23 Jacket inside pocket with pelon; pocket length 150 mm