Beisler 100-54 - Manual (Page 66)

3-12
1.20.2Measure clamp path
Switch on the machine with the mains/emergency stop
switch. Wait until the clamp has been initialized.
The machine must be in home position (clamp carriage
in the back position).
Press sequently the keys [P] – [F6] – [F3] – [F3] – [F1] at
the operation device.
Push the clamp forward into insertion position until in-
itiator 1 switches dark. Check the value which is display-
ed in the lower right corner of the display (in mm):
< 000 mm initiator 17 (see picture in section 1.20.3) is
too far in the back and must be adjusted
towards the sewing head.
= 000 mm initiator 17 is adjusted correctly.
> 000 mm initiator 17 is too far in the front and must
be adjusted away from the sewing head.
1.20 Adjust clamp path
1.20.1Adjust front stop
<release pressure>
Drive the clamp carriage (1) into insertion position intil
initiator 1 (2) switched dark. The distance (A) between
the beam and the clamp carriage must be 19 mm.
To adjust the distance, loosen the fixing screws of the
initiator 1 (2) and move him in the desired direction. Tigh-
ten the fixing screws again.
Loosen the fixing screw of the stopping rubber (3) and
turn this in or out, until there is a distance (B) of 3 mm to
the clamp carriage. Tighten the fixing screw again.
1.20.3Adjust back stop rubber
The stop rubber (1) beside initiator 17 (I 17) must show
a gap of 3 mm to the clamp carriage.
Drive the clamp carriage into home position. Loosen the
nut (2) and turn the stop rubber, until there is a distance
of 3 mm to the clamp carriage. Tighten the nut (2) again.