Beisler 100-54 - Manual (Page 31)

2-9
Photo cell right
necessary during sewing of right flap
Positioning point front
calculation point for the seam start during sewing without flap
Positioning point middle
calculation point for the seam start during sewing without flap
Positioning point rear
calculation point for the seam start during sewing without flap
Zipper scissor (option)
during sewing an endless zipper, this function gives a stop-
command to the machine to allow the cutting of the zipper
3.3 Seam parameters
Several seam-depending machine processes can be set:
1. Press the P-key.
2. Press F3.
3. Select the desired seam parameter using the arrow keys.
4. Press ENT-key.
5. Enter the desired value.
6. Repeat steps 3. to 5. for all desired seam parameters.
7. Press the P-key to leave the submenu.
During the selection of the parameters, you can scroll line per line using the
vertical arrow keys. You can also select the pages directly:
• Key 0: seam parameters 01 - 14
• Key 1: seam parameters 10 - 24
• Key 2: seam parameters 20 - 34
• Key 3: seam parameters 30 - 44
The seam parameters listed belowcan be changed. The factory-set default
configuration are shown in square brackets [ ], the possible settings in
rounded brackets ( ).
1 Change positioning point 135/225/315 mm
the set value defines the relation point of the seam
2 Insertion speed [60%] (10-90%)
clamp speed from the insertion position to the sew start position; when
photo cell is active, speed will be halved to allow a more exact
scanning; when producing with vylene, reduction to 1/3
3 Revs seam start [1500 rpm] (500 - 2000 rpm)
sewing head revs freely selectable, depending on needle- and center
knife setting
4 Revs during seam [2500 rpm] (500 - 3000 rpm)
freely programmable
5 Revs at seam end [1500 rpm] (500 - 2000 rpm)
freely programmable
6 Distance of seam start revs [5 mm] (0 - 99 mm)
distance with the revs of parameter 3