Beisler 100-54 - Manual (Page 20)

1-18
The following operational actions are explained in this chapter:
• select a sewing program
• enable/disable seams
• change seam lengths
• change sewing programs
• create new sewing programs
• program new seams
4.2.3 Select a sewing program
The current sewing program is displayed in the upper line of the display. How
to select a program:
1. Press M-key.
2. Enter the number of the desired program using the ten key pad.
3. Press ENT-key.
4.2.4 Enable/disable seams
Seams are assigned to every sewing program. All enabled seams are sewed
sequentially. Enabled seams are displayed inverted (white on black).
If a seams shall be skipped, it must be disabled. How to enable/disable a
seam:
1. Move the cursor on the desired seam using the arrow keys.
2. Press the ENT-key to enable/disable the seam.
4.2.5 Change seam length
Several parameters of the current seam are imaged in the left half of the
display (e.g. seam length, mitre knife position). You can change these
settings individually using the function keys.
All changes executed with the function keys are stored for all seams with the
same number, even if they are used in different programs.
Further information are contained in the chapter ‘4.1.1.5 Function keys’.
4.2.6 Remove and add seams
You can add seams to and remove them from sewing programs:
4.2.6.1 Remove seams
1. Select the sewing program to be changed.
2. Press the P-key.
3. Press F1.
4. Move the cursor on the seam to be removed using the arrow keys.
5. Press the M-key.
6. Repeat steps 4. and 5. for all seams to be removed.