Beisler 100-54 - Manual (Page 28)

2-6
3 Programming instructions
3.1 Create new sewing programs
The following steps are required to create a new sewing program:
1. Select memory location (Mxx).
2. Add or copy seams.
3. Adjust the seams.
3.1.1 Select a M-memory location
Due to customer-specific configuration, several M-memory locations are
occupied by sewing programs. There are enough memory locations available
for new sewing programs.
Select an available memory locationz:
1. Press the M-key.
2. Enter the number of the desired memory location (e.g. 09).
If the memory location is available, seam No. 50 is assigned six times.
3.1.2 Add seams
If existing seams shall be used in the new program, you can remove the
seams of the memory location and add the desired seams like described in
part 1 of this manual.
If you want to create new seams, you will first have to assign new numbers to
the seams, which are not used in another program.
3.1.3 Copy seams
If existing seams shall be manipulated for the new program, the seams can
be copied to a new seam number. This allows to keep the original seams
unchanged:
1. Move the cursor to the seam number, where you want to copy another
seam to (e.g. No. 45).
2. Press the P-key.
3. Press F1.
4. Press F2.
5. Enter the number of the seam, which you want to copy (e.g. 10).
6. Press the ENT-key.
Now seam No. 10 has been copied to No. 45, a new number has been
assigned. Seam No. 10 and 45 are identic. If you need more new seams, you
can assign further seam number to the program (e.g. 46, 47, 48, a.s.o.) and
copy existing seams to these numbers.
3.1.4 Adjust seams
The seams copied to seam numbers 45 ... can now be edited, without
changing the original seams, which are possibly used in other sewing
programs.
The following seam functions can be edited:
• Mitre knife position, seam lenght, a.s.o.
• Seam functions (see section 3.2)
• Seam parameter (see section 3.3)
• Seam name (see section 3.1.5)