Beisler 100-54 - Manual (Page 83)

3-27
5.3.6 Arrangement of the mitre knife during flap
pocket production
The photo shows the correct Arrangement of the mitre
knife during flap pocket production.
5.4 Split needle (Beisler sewing head)
5.4.1 Distance to cylinder of the top threat catcher
There must be a distance on at least 0.5 mm between
the pushing block of the split needle (1) and the cylinder
of the top threat catcher.
If required, loosen the fixing screws (3) of the top threat
catcher (2) and move it, until the minimum distance is
kept. Tighten the fixing screws again.
5.4.2 Center adjustment
The setting ring of the split needle (1) must be in the
middle of the rectangular metal frame while in home
position.
If required. loosen the fixing screw of the setting ring
and move him. Tighten the fixing screw again.
5.5 Vylene adjustments
5.5.1 Correct vylene adjustment
The vylene strip (3) must be seen with the inserted sli-
ding plate but set back from the front edge of the vylene
supply for the distance (A) of 3 mm.
1: Vylene plate
2: Counter knife