CITIZEN MG0000 - Manual (Page 11)

11
✩Attachment of Ferrite Core
Attach the ferrite core to the USB cable provided by referring to the illustration below.
Loop the USB cable
once at the base of
the B type connector
(side that is connected
to the communication
unit), insert the overlap-
ping portion of the
cable into the groove
inside the ferrite core
and securely close the
ferrite core.
CAUTION
Always make sure to attach the enclosed ferrite core to the USB cable prior to use.
Failure to properly attach the ferrite core may cause electromagnetic interference to
affect offect other eguipment.
Before Use
Always make sure to fully charge the watch prior to use using the
communication unit provided.
The battery (secondary battery) used by the watch is of the rechargeable type. Charging
is performed using the communication unit after installing four size AA alkaline batteries
(battery no. LR-6).
* It is not necessary to connect the watch to a PC during charging.
Charging is performed using only the batteries in the communication unit.
CAUTION
• The communication unit is not waterproof. Do not allow it to come in contact with
water or become wet. In addition, sand or dust inside the communication unit can
cause a malfunction. Use caution when using the communication unit outdoors.
• Since improper use of the batteries can result in the risk of leakage of battery fluid or
rupture, use particular caution with respect to the following items.
• Install the batteries with the polarity (+,-) correctly aligned.
• Do not mix different types of batteries installed in the communication unit.
• Do not use fresh batteries with old ones. When replacing the batteries, replace all
of the batteries with four fresh batteries of the same type.
Move to this
position