CITIZEN MG0000 - Manual (Page 24)

(3) Correct the flashing item by pressing either button (B) or button (A).
• Pressing button (B) advances the display by one step at a time, while pressing button (A)
moves the display back by one step at a time. (Pressing either button continuously causes the
display to change rapidly.)
• Refer to the section on " Locations Displayed by this Watch" for information on displayed
locations.
• The watch returns to 00 seconds simultaneous to pressing button (B) or button (A) when
correcing seconds. (If the seconds are between 30 and 59 seconds at that time the minutes
advance by 1.)
• When the display is set to switching daylight savings time (ON or OFF is flashing) or switching
the 12H/24H format, the display switches back and forth between the settings each time
button (A) or button (B) is pressed.
(4) Pressing button (D) returns the watch to the normal display.
* The year can be set from 2000 to 2099. However, January 1, 2000 is designated as a special
date for use by the hardware system of this watch. If the watch is attempted to be used for
infrared or USB communication or is switched to the low power mode while set to this date,
all the display elements on the watch are displayed and the watch returns to the initial setting.
Please do not set your watch to January 1, 2000.
* Once the date has been set, it is not necessary to correct for leap years or the end of the
month. (Dates such as February 30 that do not actually exist are not displayed even during
correction.)
* Pay attention to AM (A) and PM (P) when using the 12 hour format.
* When daylight savings time has been set (ON), the time advances by 1 hour from the current
time and "ST" appears on the display. Daylight savings time cannot be set for Coordinated
Universal Time (UTC).
* The day is corrected automatically by correcting the year, month and date.
* The watch automatically returns to the normal display when none of the buttons are pressed
for about 3 minutes in the correction state (display flashing).
* The watch can be immediately returned to the normal display by pressing button (D) in the
correction state (display flashing).
C. Daily Graphic
The daily graph is set with the "CAPgm" PC software. The graphic registered for daily
graphic is displayed each day in the lower right section of the Day Display. In addition,
daily graphics registered for anniversaries are preferentially displayed on days on which
anniversaries have been set. Refer to the "CAPgm" user’s manual provided with the
accessory software contained on the CD-ROM for further details on setting and displaying
daily graphics.
24