CITIZEN MG0000 - Manual (Page 25)

2. Travel Time Mode
The travel time mode is used to display the date and time of another location separate
from the Main Time of the time mode (Main time). Simply select a location desired to be
displayed in the travel time mode from the pre-registered locations to automatically display
the time and date for that location as determined by converting the time difference. In
addition, the location displayed in the travel time mode and the location displayed in the
time mode can be easily interchanged.
A. Switching the Display
The time difference from the Coordinated Universal Time (UTC) along with the time
difference from the time in the time mode are displayed for as long as button (B) is
pressed in the travel time mode.
B. Setting the Travel Time
(1) The location flashes when button (C) is pressed for at least
2 seconds in the travel time mode.
(2) The location is changed by pressing button (B) or button (A).
• Pressing button (B) calls up the next location each time it is
pressed, while pressing button (A) calls up the next location in
the reverse order each time it is pressed. (Pressing either button
continuously enables the location to be changed rapidly.)
• Refer to the section on " Locations Displayed by this Watch" for information on displayed
locations.
(3) The setting for daylight savings time (ON (set) or OFF (canceled)) flashes when button
(C) is pressed.
(4) Daylight savings time is corrected by pressing button (B) or button (A).
• The display switches back and forth between the settings each time button (A) or button (B) is
pressed.
(5) Pressing button (D) returns the watch to the normal display.
* The 12 hour or 24 hour format is used in accordance with the setting in the time mode.
* Daylight savings time cannot be set for Coordinated Universal Time (UTC).
* In the case the setting for daylight savings time is changed when the location in the travel time
mode is the same as the location in the time mode, the setting for daylight savings time is
applied to the time mode as well.
* The watch automatically returns to the normal display of the travel time mode when none of
the buttons are pressed for about 3 minutes in the correction state (display flashing).
* The watch can be immediately returned to the normal display of the travel location mode by
pressing button (D) in the correction state (display flashing).
* The watch automatically returns to the time mode when none of the buttons are pressed for
about 3 minutes in the travel time mode.
25
( C ) ( B )
( D ) ( A )
( C ) ( B )
( D ) ( A )
[Normal Display]
Location
Time
(B)
Month, date
Flashing
Time difference from
UTC
Time difference from
time in time mode
[Time Difference Display]