CITIZEN MG0000 - Manual (Page 18)

Display Mode (Functions)
Standard Mode
The watch is usually used in this mode. The standard mode consists of the following
seven sub-modes.
1. Time Mode
In this mode, the watch is used to display and correct the time and date (main time)
that are the basic parameters of this watch. This mode is normally displayed when
wearing the watch.
2. Travel Time Mode
In this mode, the watch displays the time and date for a different location from the time
mode.
3. Destination Timer Mode
In this mode, the watch displays the time remaining until a preset arrival time in 1
second units after a destination and arrival time have been preset. This convenient
function can be used when traveling or on business overseas.
* Maximum measuring range: 99 hours 59 minutes 59 seconds
4. Alarm Mode
In this mode, the watch can be used to switch the alarm on and off and correct the
alarm time.
5. Chronograph Mode
In this mode, the watch measures time with a chronograph up to 99 hours, 59 minutes
59.99 seconds.
6. Timer Mode
In this mode, the watch measures time with a count down timer in 1 second units (and
can be set up to 99 minutes in 1 minute units).
7. System Monitor Mode /
In this mode, the watch displays the charge level of the secondary battery along with a
general indication of the usage status of flash memory.
Dive Plan Mode
This mode is used to prepare a plan for the next dive. In this mode, the watch displays the
no-decompression limit time during the next dive and is used to set the dive alarms to be
used during the next dive.
Scuba Log Mode - SCUBA
This mode is used to confirm the logs of previous scuba diving. In this mode, the watch
displays various data (logs) for scuba diving automatically recorded while diving.
Skin Log Mode - SKIN
This mode is used to confirm the logs of previous skin diving. In this mode, the watch
displays various data (logs) for skin diving automatically recorded while diving.
18