Ending the dive mode, Using the surface mode, Warning – CITIZEN MG0000 User Manual
Page 48
6. Ending the Dive Mode
• The watch returns to the surface mode or the time mode of the
standard mode when button (D) is pressed for at least 2 seconds
when 0 m (0 ft) is displayed after completion of water depth
measurement.
• The watch automatically returns to the surface mode or time mode
of the standard mode after roughly 10 minutes have elapsed since
0 m (0 ft) is displayed following water depth measurement.
Using the Surface Mode
The surface mode is used to display elapsed time from the end of the most recent scuba
dive (S.I. time) and the amount of time remaining until boarding an aircraft is permitted (no
fly time).
WARNING
Avoid traveling in an aircraft while the surface mode is activated. Traveling in an
aircraft without allowing sufficient time to rest after diving results in the risk of
decompression sickness. It is recommended to avoid traveling in an aircraft for at
least 24 hours after diving whenever possible even if the surface mode is no longer
displayed. There are no rules for completely preventing decompression sickness
caused by flying in an aircraft after diving.
* This mode is preferentially displayed at all times after scuba diving.
* When the no fly time reaches 0 hours 00 minutes, the watch returns to the time mode of the
standard mode from the surface mode. The surface mode is not displayed after that time until
completion of the next scuba dive.
48
Surface interval time
No fly mark
Current time
No fly taime
(
C
)
(
B
)
(
D
)
(
A
)
(
C
)
(
B
)
(
D
)
(
A
)
0 m (0 ft) display after
completion of water
depth measurement