CITIZEN MG0000 - Manual (Page 27)

A. Setting the Destination Timer
(1) The watch switches to the correction state (display flashes)
when button (C) is pressed for at least 2 seconds in the
destination timer mode.
(2) The flashing item changes in the order shown below each time
button (C) is pressed.
(3) The flashing item can be corrected by pressing either button (B) or button (A).
• Pressing button (B) advances the display by one step at a time, while pressing button (A)
moves the display back by one step at a time. (Pressing either button continuously causes the
display to change rapidly.)
• Refer to the section on " Locations Displayed by this Watch" for information on displayed
locations.
• When switching daylight savings time (ON or OFF is flashing), the display switches back and
forth between the settings each time button (A) or button (B) is pressed.
• When button (B) is pressed while in the alarm number selection state (an alarm number is
flashing), the next alarm number is called up each time it is pressed. When button (A) is
pressed in the alarm number selection state, the next alarm number is called up in the reverse
order each time it is pressed. Select "Silent" when you do not want the alarm to sound.
• You can monitor the alarm corresponding to the flashing alarm number by pressing button (B)
or button (A) in the alarm number selection state for as long as the button is pressed. (The next
or previous alarm number is momentarily displayed the instant the button is pressed, while
pressing either button continuously causes the set alarm to sound.)
(4) Pressing button (D) finalizes the setting after which the destination timer starts to run
and the remaining time until the arrival time is displayed.
* The 12 hour or 24 hour format setting is in accordance with the setting in the time mode.
* In the case the remaining time until the set arrival time exceeds 100 hours, the destination
timer stops at the arrival time display and then starts running automatically when the remaining
time until the arrival time is within 99 hours, 59 minutes and 59 seconds.
* When the arrival time has been set going back more than 100 hours, the destination timer
stops at the arrival time display.
* In the case of correcting the arrival time while the destination timer is running, the destination
timer starts running according to the newly set arrival time.
* The remaining time is recalculated in the case the time or daylight savings time setting is
corrected for the location set with the destination timer in the time mode or travel time mode
while the destination timer is running.
* The watch automatically returns to the arrival time display or remaining time display when
none of the buttons are pressed for about 3 minutes in the correction state (display flashing).
* The watch can be immediately returned to the arrival time display or remaining time display by
pressing button (D) in the correction state (display flashing).
27
Alarm
number
Minutes Hours Date
Location
Daylight savings
time switching
Year Month
Flashing
(C) (C) (C)
(C)
(C) (C) (C)