CITIZEN MG0000 - Manual (Page 42)

3. Dive Alarm
<Depth Alarm>
The depth display flashes and an alarm sounds for 15 seconds at 1 minute intervals (for
the set number of times) to warn the diver when the diver remains at a depth deeper than
the set depth while diving. The alarm stops sounding when the diver ascends to a depth
less than the set depth, and sounds again if the diver descends deeper than the set depth.
• Setting range: 10 m (30 ft) to 39 m (130 ft) (1 m (5 ft) units), OFF
• No. of times alarm sounds: 1 to 5 times, ON (no limit)
<Dive Time Alarm>
The dive time display flashes and an alarm sounds for 15 seconds when the set time
elapses from the start of the dive. This alarm sounds only once.
• Setting range: 5 min to 90 min (5 min intervals), OFF
4. Setting the Dive Alarm
(1) The watch enters the correction state (display is flashing) when
button (C) is pressed for at least 2 seconds during the dive
alarm display. The flashing item on the display can be
corrected.
(2) The flashing item changes in the order shown below each time
button (C) is pressed.
(3) Correct the flashing item by pressing either button (B) or button (A).
• Pressing button (B) advances the display by one step at a time, while pressing button (A)
moves the display back by one step at a time. (Pressing either button continuously causes the
display to change rapidly.)
• Correction of the number of times the alarm sounds is skipped when the depth alarm is set to
OFF.
(4) Pressing button (D) finalizes the settings.
* Set each parameter to OFF when you do not want the depth alarm and dive time alarm to
sound.
* The watch automatically returns to the normal dive alarm display when none of the buttons are
pressed for about 3 minutes in the correction state (display flashing).
* The watch can be immediately returned to the normal dive alarm display by pressing button (D)
in the correction state (display flashing).
5. Dive Alarm Monitor
Each alarm sound repeatedly sounds for 4 seconds each in the order of the depth alarm,
dive time alarm and ascent rate alarm for as long as button (B) is pressed during the dive
alarm display.
* Refer to the section on " Warning Functions" for information on the ascent rate warning alarm.
42
Depth
No. of times
alarm sounds
Dive time
Flashing
(C) (C)