Form length – Compuprint 9060LA User Manual
Page 107
103
S
S
e
e
t
t
t
t
i
i
n
n
g
g
t
t
h
h
e
e
P
P
a
a
g
g
e
e
L
L
a
a
y
y
o
o
u
u
t
t
For correct paper feeding, you must tell your printer which paper format you loaded into the
printer and which area you want to define for printing.
Form Length
The
FORM LENGTH
Option allows you to set the physical form length in inches or in number of
lines. Even if the logical definition of the form length changes according to interdependent
Option settings, the Value of the
FORM LENGTH
Option is not altered as a result. It is only
altered by software command.
–
The Factory setting for the
FORM LENGTH
Option is 11 inches (A) predetermined Value.
The other predetermined Values in inches are: 3, 3.5, 4, 5.5, 6, 7, 8, 8.5, A4 (11.6 inches),
12, 14 or 15 inches.
Each time you change the form length using a predetermined Value:
•
The
TOP MARGIN
Option is set to Line #1
•
The
BOTTOM MARGIN
Option is set to the maximum Value, according to the formula:
Bottom margin (Line #X = Form Length (inches) x Vertical pitch (lpi)
(unit conversion is automatic if you define the vertical pitch unit as lpcm).
–
The
NUMBER OF LINES
Sub-option gives you the possibility to define the logical form
length as a number of lines. This length comes then from the following formula:
Form length (inches) = Vertical pitch (lpi) x Number of lines
(unit conversion is automatic if you define the vertical pitch unit as lpcm)
The maximum authorized form length is 21 inches.