Compuprint 9060LA - Manual (Page 108)

104
The TOP MARGIN and BOTTOM MARGIN Options do not depend on the VERTICAL PITCH Option
when you define the form length using the NUMBER OF LINES Sub-option.
Left Margin
The LEFT MARGIN Option is defined by the number of the columns (numbered from the left
paper edge) where the printing actually starts. The values range between Column #1 and
Column #272.
Form Width
The FORM WIDTH Option lets you set the correct page width in inches. The available values are
8, 13.2 and 13.6 inches. The Factory setting of the Value is 13.6 inches .
The current value of the LEFT MARGIN Option is set to Column #1 each time you change the
value of the HORIZONTAL PITCH Option. This new setting applies only for the corresponding
protocol.
Top Margin
The TOP MARGIN Option lets you set the top margin with the number of the line (numbered from
the top paper edge) where the printing actually starts.
The setting of this Option depends on the setting of both the VERTICAL PITCH and the FORM
LENGTH Options (see the corresponding related sections in this chapter).
The Values range from Line #1 to the Value corresponding to the BOTTOM MARGIN setting.
Line #1 is the Factory setting of the Value.