Printing on adhesive labels – Compuprint 9060LA User Manual
Page 56
52
P
P
r
r
i
i
n
n
t
t
i
i
n
n
g
g
o
o
n
n
A
A
d
d
h
h
e
e
s
s
i
i
v
v
e
e
L
L
a
a
b
b
e
e
l
l
s
s
When printing on adhesive labels you must disable the backward movement of the paper,
because the unsticking of the labels can cause paper jams when the paper is moved backwards.
Proceed as follows:
1. Press the
Set-Up
button to put the printer in Set-Up mode.
The display shows
MACROS
.
2. Press the
↓
button.
MACRO X
is displayed, where
X
is the number of the current Macro.
3. Press the
↓
button.
The display shows
PROTOCOL
.
4. Press the
→
button until the
TEAR/VIEW MODE
Option is displayed.
5. Press the
↓
button to pass over to the Values for the Tear/View mode.
6. Press the
→
or
←
button, until
No tear/reverse
is displayed.
7. Press the
Sel/Save
button to set confirm the new setting. An asterisk is displayed to indicate
that the Value has been selected.
8. Press the
Exit
button to exit the Set-Up mode.
The message "
Save config
." appears, indicating that you are going to save your new
setting.
9. To permanently save your choice, press the
Sel/Save
button.
It is not necessary to perform the above operation when using the Push-Pull paper path, as all
backwards movements are inhibited with this path. We recommend using the Push-Pull path
when printing on adhesive labels, but note however that the printing of landscape barcodes may
generate backward movements.