Compuprint 9060LA - Manual (Page 73)

69
Adjusting the Top of Form from the Operator Panel
Adjusting the Top of Form from the Operator Panel affects the current Macro setting if you
decide to permanently save your setting.
Proceed as follows:
1. Press the Set-Up button.
2. Press the Top of Form button. The printer loads the paper in the current paper path. The
display shows the current Top of Form value.
3. Press the
↑
or
↓
button to move the paper position respectively up or down in steps of
1/60 inch. The new Top of Form value appears on the display.
4. When the desired setting is reached:
– to temporarily save the Top of Form Value, press the Exit button
–
to permanently save the Top of Form Value, press the Sel/Save button.
The paper moves back to its previous position.
To reset the Top of Form Value:
•
If you want to quickly reset the Top of Form Value to 0/60 inch, press the Top of Form
button during the procedure described above.
The paper moves to the corresponding
Top of Form Value, then returns to its previous
position.