Flowserve 500+ Series Logix - Manual (Page 9)

User Instructions - Logix® 500+ Series Digital Positioners FCD LGENIM0105-10 11/13
flowserve.com 9
2.7 Limit Switch Specifications
Table 7: Limit Switch Specifications
For entity parameters, see section 3 HAZARDOUS AREA
CERTIFICATIONS.
Switch Specifications
Mechanical
Cherry DG 13-B(X)RA
NO and/or NC
General Purpose Only
Load Current: 3/2 AAC/ADC
Voltage: 125/30 VAC/VDC
Temperature: -25 to +85 °C
(-13 °F to 185 °F)
Reed
Hamlin 59050-030
NO Load Current: 500 mA
Voltage:
200VDC
Temperature: -40 to +105 °C
(-40 °F to 221 °F)
Inductive Sensor
P&F NJ2-V3-N
NAMUR NC -3 Load Current:
Plate: ≤ 1 mA;
No Pla
te: ≥ 3 mA
Voltage: Nominal 8.2 VDC
Temperature: -25 °C to 100 °C
(-13 °F to 212 °F)
Inductive Proximity
P&F SJ2-S1N
NAMUR NO-4 Load Current: Plate: ≤ 1 mA;
No Plate: ≥ 3 mA
Voltage: 5-25 VDC
(Nominal 8 VDC)
Temperature: -25 °C to 100 °C
(-13 °F to 212 °F)
Inductive Proximity
P&F SJ2-SN
NAMUR NC-5 Load Current: Plate: ≤ 1 mA;
No Plate: ≥ 3 mA
Voltage: 5-25 VDC
(Nominal 8 VDC)
Temperature: -40 °C to 100 °C
(-40 °F to 212 °F)
Inductive Sensor
P&F NBB2-V3-E2
PNP NO
General Purpose Only
Load Current: 0…100 mA
Voltage: 10...30 VDC
Temperature: -25 °C to 70 °C
(-13 °F to 158 °F)
2.8 Positioner Performance
Characteristics
Table 8: Performance Characteristics
Better than or equal to the following values on a 25 square inch
Mark I actuator.
Resolution ≤ 0.25%
Linearity +/-1.25%
Repeatability ≤ 0.25%
Hysteresis ≤ 1.0%
Deadband ≤ 0.3%
Sensitivity ≤ 0.25%
Stability ≤ 0.4%
Long term drift ≤ 0.5%
Supply Pressure Effect ≤ 0.2%

NOTE: Performance tested according to ISA 75.13.
2.9 Physical Specifications
Table 9: Physical Specifications
For dimensions, see section 19 POSITIONER .
Housing Material Cast, powder-painted aluminum
EN AC-AlSi12(Fe)
Soft Goods Fluorosilicone
Weight of Base
Positioner Without
Accessories With Single Acting Relay
1.76 kg (3,88 lb)
With Double Acting Relay
1.88 kg (4.14 lb)
2.10 Temperature
Table 10: Temperature
Operating Temperature
Range -52 to 85°C (-61.6 to 185°F)
Transport and Storage
Range -52 to 85°C (-61.6 to 185°F)

NOTE: Reduced performance possible at low
temperatures.
2.11 ValveSight DTM Software
Specifications
Table 11: ValveSight DTM Software Specifications
Computer Minimum Pentium processor running
Windows 95, 98, NT, 2000, XP, 7, 32 MB
total memory (64 MB recommended), 30
MB available hard disk space, CD-ROM
drive
Ports 1 minimum available with 8 maximum
possible. (Can also communicate via
serial, PCMCIA and USB connections)
HART Modem RS-232,
PCMCIA card, or
USB
HART Filter May be required in conjunction with some
DCS hardware.
HART MUX MTL 4840/ELCON 2700