FSR HuddleVU - Manual (Page 32)

32
Huddle-VU
HELP REQUEST
The user will be able to request a list of the valid commands with descriptions and formats. The format for
this request is as follows:
HLP [cmd] <cr>
HLP [cmd] <cr>
Syntax: HLP [cmd]<cr>
Where:
HLP Help Request header
cmd optional command identifi er
If the optional cmd is omitted, the HV-CTL will respond with the following text message:
CON Connect specifi ed input.
HLP Provides help information for HV-CTL command set.
LOCK Lock a specifi ed input from switch recognition.
PWR Controls the state of the HV-CTL switched AC receptacles and AUX relay output
RLY Controls the state of the HV-CTL switched AC receptacles and AUX relay output
RSP Request or decline a response.
SBR Confi gure serial bit rate of serial port 1 or 2.
STA Request status of currently connected input.
UNLOCK Unlock a specifi ed input for switch recognition.
VER Request current part # and version number.
VRB Turns on or off verbose command error reporting.
Entering HLP <cmd><cr>, where cmd is any valid HV-CTL command in the above list, will return specifi c
help syntax for the command requested. If the user would like more detailed help for a specifi c command
then it is necessary to turn on verbose mode using the VRB Y command syntax. This will enable returning a
description of the parameters of any specifi c command. The user may return to non-verbose mode by issuing
the VRB N command.
Specifi c command help is listed below.
CON <"1"|"2"|"3"|"4"|"5"|"6"|"7"> |<"?"><cr>
Connect specifi ed program input
"1"|"2"|"3"|"4"|"5"|"6"|"7" Input to connect
"?" ? for inquiring currently confi gured source.
HLP[ cmd]<cr>
Provides help information for the HV-CTL command set.
cmd
optional command identifi er
LOCK <"1"|"2"|"3"|"4"|"5"|"6"|"7">|<"ALL"> |<"?"><cr>
Lock a specifi ed switch input from recognition.
1-7 = Switch input to be ignored.
"ALL" = Lock all switch inputs.
"?" = Request current lock status.