Mounting information, Hv-t3 table box installation, 6huddle-vu – FSR HuddleVU User Manual

Page 6

Advertising
background image

6

Huddle-VU

MOUNTING INFORMATION

HV-T3 INSTALLATION INSTRUCTIONS

SLOTS USED FOR 5/8" TO
1-1/8" THICK TABLE TOPS

SLOTS USED FOR 1-1/8" TO
1-9/16" THICK TABLE TOPS

3.50" DIAMETER

(2) MOUNTING

CLAMP

(2) MOUNTING

SCREW

MOUNTING

CLAMP AND

MOUNTING

SCREW

INSTALLED

MOUNTING

CLAMP AND

MOUNTING

SCREW

(SEE BELOW)

HV-T3 ASSEMBLY

TABLE

DRILL 3.50" DIAMETER HOLE IN TABLE TOP.

1.

2. INSERT HV-T3 ASSEMBLY AND ORIENT AS REQUIRED.

3. INSTALL MOUNTING CLAMPS TO ASSEMBLY AND SECURE TO TABLE BY

SCREWING MOUNTING SCREWS TO UNDERSIDE OF TABLE.

MAKE ELECTRICAL CONNECTIONS AS REQUIRED. ENSURE HDMI
CONNECTOR CAN BE PULLED OUT 3'-0".

4.

CUSTOMER TO PROVIDE

KO SLUG/PENNY/OTHER

HARD FLAT PIECE FOR

SCREW END, WITH SOFT

TABLE WOOD

HV-T3 TABLE BOX INSTALLATION

NOTE: TABLE BOXES ARE AUTOMATICALLY
GROUNDED WHEN THAY ARE PLUGGED INTO AN
AC OUTLET. IF THE UNITS ARE NOT PLUGGED
INTO AN AC OUTLET THEY MUST BE MANUALLY
GROUNDED.

Advertising
This manual is related to the following products: