Wall mount – Gasboy 70 Series User Manual
Page 16
GASBOY Series 70 & 1820
2-8
MDE-4423B Series 70 and 1800 Consumer Elect Pumps Installation/Operation/Parts
●
July 2005
Wall Mount
The optional wall mount kit can be used with any Series 70 or 1820 pump to be located remote
from the tank. The wall mount kit consists of a wall-mounting bracket, pump mounting flange, and
hardware to attach the flange to the bracket. Hardware to attach the bracket to the wall is not
included.
1.
Fasten mounting bracket to wall using appropriate 3/8-inch fasteners (customer supplied).
2.
Screw mounting flange to pump inlet. The flange with the four holes should be away from
the pump. Pipe thread compound is not required. Tighten flange and align parallel with
pump.
3.
Bolt mounting flange to mounting bracket using the hardware supplied.
4.
Remove the 1-inch plastic plug within the 2-inch pump base inlet and install the 1-inch inlet
NPT inlet line from the tank into the pump. Apply gasoline-resistant pipe compound to male
threads. Follow piping instructions shown on previous page for piping to the tank.
See
the
Conduit section for correct installation of electrical conduit.