Gasboy 70 Series - Manual (Page 25)

Start-Up and Operation
MDE-4423B Series 70 and 1800 Consumer Elect Pumps Installation/Operation/Parts
●
July 2005 4-3
Strainer Cleaning
Clean the strainer immediately after the pump has been installed and tested, and again after a few
hundred gallons have been delivered. Thereafter, clean the strainer once every six months, or as
required. The procedure for cleaning the strainer can be found in the Maintenance and
Troubleshooting section.
DAILY OPERATION
1.
To begin fueling, remove the nozzle from the boot and turn on the pump handle.
2.
If your model has an automatic reset, the register resets to zeros. If your model has a reset
button, push it to zero the register.
3. Dispense
fuel.
4.
Turn the pump handle off. The amount delivered is displayed on the register.