Shutting down island, Removing existing equipment, Mounting dry islander plus – Gasboy PLUS FMS User Manual
Page 13: Important information, Caution
MDE-5067 FedEx Islander PLUS FMS Installation Manual · March 2013
Page 3-3
Before You Begin
Shutting Down Island
For issues locating the FedEx Fleet Manager, contact Travis Langston at 1-870-704-5230.
IMPORTANT INFORMATION
Ensure that the facility personnel (Operations Manager) is aware of these steps before the old
equipment is removed. Name and contact information for the Operations Manager and site
installation parameters will be sent to you by Bob Griffith (1-336-547-5654).
FedEx Project Site Information Form, includes the following [for an example, refer to
Project Site Information Form (Example Only)”
on
]:
• Operations Manager’s Name and Phone Number.
• Fipay Server IP Address, Subnet Mask, and Gateway IP Address.
• SiteOmat Wide Area Network [WAN Local Area Network (LAN2)] IP Address, Subnet
Mask, and Gateway IP Address.
• FedEx Alpha code - SiteOmat Station Name or Description.
• Site Number - SiteOmat Station Code.
The circuit panel must be locked out, tagged out as per normal Gilbarco
®
safety procedures
found in the Gilbarco LMS training modul
information,
refer to
GVRSAFEUS50-012 GVR Fueling Site Safety.
CAUTION
Removing Existing Equipment
The Gasboy Fleet PLUS system will use some of the same control and communication wiring
as other third-party FMS. To aid in efficient installation, all control wiring in an existing
system must be labeled before disconnection.
Mounting Dry Islander PLUS
To mount the Islander PLUS in the facility, proceed as follows:
1
When installing the Gasboy Islander PLUS at a facility with existing conduits at the fuel
island, it is important to note the dimensions of the pedestal to determine if special fabrication
is required for the conduits (see
2
The pedestal can be cut within UL parameters from the base plate up to 18 inches. Any holes
drilled in the pedestal must only be large enough to fit conduit elbows and must not be inserted
above the IS Barrier Plate.
3
Following conduits are required for the Gasboy Islander PLUS pedestal:
• High Voltage (AC power, pump control, ground, in-use for mechanical dispensers).
• Low Voltage (pulser, tank gauge, and LAN).