Gasboy PLUS FMS User Manual
Page 15
MDE-5067 FedEx Islander PLUS FMS Installation Manual · March 2013
Page 3-5
Before You Begin
5
Make a template of the conduit configuration for the cutouts in the barrier plate. The cutouts in
the plate must only be cut large enough for the wiring to be pulled through. You will also want
to install conduit gaskets to prevent wire damage (see
Figure 3-2: Conduit Configuration in Barrier Plate
A3
φ 11 (X4)
With Knockout Cover
φ Insert PEM CLS-M4X1
From Other Side (X4)
A3
φ 28.5 (X4) With Knockout Cover
6
After the pedestal and conduit needs are addressed, place the base plate over the conduits,
wider side faced towards the front of the unit, and mark the island along the outside edge of the
base plate as well as the inside holes for the lag bolt placement (see
).
Figure 3-3: Base Plate on Conduits
Front of Base - Wide Side
Wide Side