Dish Network 942 - Manual (Page 101)

Chapter 10
94
Tips
T
IPS
• If using a specific channel for TV2 (for example, channel 60), TV2’s remote control
must be programmed with a TV2 channel/input before you can use RECOVER.
• Place the channel sticker on the remote TV and write down the channel you use to
watch DISH Network programming. The stickers are inside the front cover of this
guide.
• If you don’t want to accidentally change channels on your TV or VCR, try
programming the remote control in Limited Mode as described on page 81.
• Make sure you have a UHF antenna connected so you can use Remote Control 2.
See page 17 for instructions.
Q
UESTIONS
• My remote doesn’t control my receiver or other components. What should I do?
– Put the remote control is in the correct mode (page 81).
– Check the remote control address (pages 79 and 85).
– Check the batteries (page 17).
– Check the UHF antenna (page 17).
– Adjust the UHF antenna (page 80).
• Why does my receiver change channels or display menus at random? Your
neighbor may have their remote control set on the same address. Change the
address on your remote control and receiver as described on page 78. If that doesn’t
help, you may have to install a UHF attenuator as described on page 80.
Chapter 10 Two Color.fm Page 94 Tuesday, June 7, 2005 1:17 PM