Dish Network 942 - Manual (Page 118)

Connections and Setup
111
Connecting to the Remote TVs (TV2)
13
With the Modulator Setup screen displayed on the nearby HDTV, use Remote Control 1 to
do the following:
a
Under TV2 Out, select either Air (for off-air channel numbers) or Cable (for cable
channel numbers) based on what you wrote down in step 5.
b
Under TV2 Out, use the UP and DOWN ARROWS to change the modulator channel
to the one you wrote in step 5.
c
Select Done.
14
For some TVs, you must run a channel scan so that the TVs will find and display the
selected channel from the receiver. Run channel scan on all remote TV(s), if available.
See your TV user’s guide for instructions.
15
Confirm that you see a picture from the receiver TV2 output on your remote TV(s).
• If your picture looks good, go to step 23.
• If your TV(s) do not have a picture or if it is not as clear as you would like it to be, go to
the next step.
16
You may need to change the cable connection on the splitter that sends the TV signal
throughout your house. The change that needs to be made is move the cable coming from
the receiver CH 21-69 Out from the output of the splitter to the input of the splitter using
the instructions that follow.
The following figure shows an example of what your splitter may look like. Your splitter
may look different. The places where the splitter indicates Out refers to all TVs connected
to your cable system. The places where the splitter indicates In refers to where the TV
signal is fed into the splitter.
17
Find where the TV signal is distributed throughout your house. It should be near where the
cable TV service enters the house.
18
Disconnect the cable TV service cable or antenna cable from the splitter input, if neces-
sary. Make sure the disconnected cable is capped or otherwise protected from the
weather.
1 Input, 4 Output (4-Way) Splitter
Chapter 12 Two Color.fm Page 111 Tuesday, June 7, 2005 1:22 PM