Dish Network 942 - Manual (Page 90)

Remote Controls
83
Controlling Other Components
Setting Up Using Device Codes Scan
If the code for your device is not listed in the tables starting on page 136, use this
procedure to scan the remote control’s memory for the device code. In the instructions
below, the column on the left contains the instructions and the column on the right
provides additional information.
7
Press POUND (#). If you entered the code correctly, the mode
button flashes three times.
8
Press POWER to turn off the device. If
the device does not turn off, go to
step 10. If the code works, the device should turn off.
9
Turn the device back on and try some
other buttons to make sure they work.
If the code works for other buttons,
stop here. Sometimes POWER works when other buttons
don’t.
10
If the code doesn’t work, redo steps 3
through 9 with another device code
from the tables. Try every code listed for your brand until one
works for your device.
11
If you can’t find a code that works try,
Setting Up Using Device Codes Scan
that follows.
Instructions Additional Information
Chapter 10 Two Color.fm Page 83 Tuesday, June 7, 2005 1:17 PM