Dish Network 942 - Manual (Page 91)

Chapter 10
84
Controlling Other Components
Instructions Additional Information
1
Turn the device on. Use the device’s front panel buttons or its
remote control.
2
Press and hold the mode button until
all the other mode buttons light up, and
then let go of the button. The mode
button flashes. For example, hold TV for a TV until all of the
other mode buttons light. When you let go, TV
will flash.
3
For AUX mode only. Press 0 for a
second TV, or 1 for a second VCR,
or 2 for a tuner, or amplifier. Then press
the STAR (*) button. This step is for programming which kind of
device that should be programmed in AUX
mode. If you’re not programming in AUX mode,
skip to step 4.
4
Press POWER. This puts your remote in the scan mode.
5
Press the UP or DOWN ARROW
repeatedly until the device turns off. As you press the UP or DOWN ARROW, the
remote tries each code in the memory to see if
it can turn off your device. When the device
turns off, you have found a code that might
work.
Note: The mode button for the device will flash
rapidly eight times when you’ve scanned all the
codes for that device.
6
Press POUND (#). The mode button flashes three times if you
have entered the code correctly. This stores the
code you found.
7
Turn the device back on and try some
other buttons to make sure they work. Press POWER to turn the device back on. Try
some other buttons to make sure they work.
Sometimes POWER works when other buttons
don’t.
8
If necessary, repeat this procedure until
you’ve tried all the codes. You may need to repeat the scan to find the
best code for your device.
Chapter 10 Two Color.fm Page 84 Tuesday, June 7, 2005 1:17 PM