Dish Network 942 - Manual (Page 98)

Remote Controls
91
The Recover Button
Programming the Recover Button for Remote Control 2
When your Remote Control 2 is shipped from the factory, RECOVER is set up to restore
satellite TV viewing by tuning your TV (or VCR) to channel 3, 4, and other inputs.
However, to use RECOVER with your remote TV (or VCR), you need to program
RECOVER with the specific channel (for example, channel 60) that you use to watch TV2
programming. The following instructions describe how to program RECOVER to tune your
remote TV (or VCR) back to a selected channel.
1
Program Remote Control 2 to control your remote TV (and VCR, if applicable) using the
instructions in Controlling Other Components on page 81.
2
Press and hold the TV mode (or VCR, if applicable) button until all the other mode buttons
light up, and then let go of the button. The TV flashes.
3
Press FORMAT/STAR (*).
4
Enter the two digits of your channel number. For example, if your remote TV (or VCR) is
set to channel 60, enter 6-0.
5
Press POUND (#). the TV mode button flashes three times.
Using the Recover Button
The following setup is required to use RECOVER:
• The remote control must be set up to control the TV and, if installed, the VCR.
• If a VCR is installed, make sure it is connected as shown on page 115.
• On a remote TV, RECOVER must be programmed to tune your remote TV to the spe-
cific channel to receive TV2 programming (for example, channel 60), using the
instructions on page 91.
Chapter 10 Two Color.fm Page 91 Tuesday, June 7, 2005 1:17 PM