Dish Network 942 - Manual (Page 31)

Chapter 2
24
Satellite Receiver Back Panel
1 The CH 21–69 OUT connection provides good quality video and
stereo audio for the remote TV(s). Use a coaxial cable to make
this connection to your home cable system. Remote TVs
connected to the home cable system can receive programming
from this receiver output. The CH 21–69 OUT connection is color
coded yellow.
2
The TV2 AUDIO and VIDEO outputs provide better picture quality
and stereo sound to your TV (if your TV has these connections).
These outputs can be used to provide TV2 menus and
programming to a wireless audio/video transmitter or to a second
input on a nearby TV. Use an RCA-type cable assembly to make
the connection. If the TV has only one input for this type of audio,
connect it to the left (L) phono (RCA) audio output on the receiver.
3
These TV1 audio outputs provide stereo sound to your nearby
HDTV (if your TV has these connections). Use RCA-type cables to
make the connection. If the TV has only one input for this type of
audio, connect it to the left (L) phono (RCA) audio output on the
receiver.
4
The TV1 Digital Audio OUTPUT is for use with high-quality digital
sound decoding systems. Connect the Digital Audio Output with a
Digital Audio Optical cable (available at consumer electronics
stores).
5 The PHONE jack is used to connect the receiver to an active
telephone line. Use a standard RJ-11 telephone cable to make the
connection. You must keep the receiver connected to an active
telephone line to use all of the dish home features, or certain other
services from DISH Network.
Chapter 2 Two Color.fm Page 24 Tuesday, June 7, 2005 12:52 PM