Dish Network 942 - Manual (Page 92)

Remote Controls
85
Controlling Other Components
Checking the Device Codes
You can find out what device code you’ve set for each remote control mode (TV, VCR, and
AUX)
.
Instructions Additional Information
1
Press and hold the appropriate mode
button until all the other mode buttons
light up, and then let go of the button.
The mode button flashes. For example, hold TV for a TV until all of the
other mode buttons light. When you let go, TV
will flash.
2
Press the Pound (#) button twice.
Watch the mode light to determine your
code. The mode button flashes the
number for each digit of the device
code, with a pause between the groups
of flashes. A quick flash is for zero. For example, if the code is 570, the mode
button flashes five times, pauses, flashes
seven times, pauses, and flashes once quickly.
For AUX mode: The first group of
flashes tells you what the AUX mode
controls. A quick flash (zero) before the
three-digit code is for a TV; one regular
flash is for a VCR; and two flashes is
for a tuner, or amplifier. For example, if the TV code is 570, the AUX
mode button flashes once quickly (indicating 0
for TV), pauses, flashes five times, pauses,
flashes seven times, pauses, and flashes once
quickly.
For a satellite receiver programmed in
AUX mode: The AUX mode button will
flash the same number of times as the
address number. For example, if the receiver address is 3, the
AUX mode button flashes three times.
For Limited Mode: If you have
programmed a TV or VCR in Limited
Mode, the mode button flashes once at
the end of the flash sequence. For example, if the TV code is 570, the AUX
mode button flashes once quickly (indicating 0
for TV), pauses, flashes five times, pauses,
flashes seven times, pauses, flashes once
quickly, and then flashes once (indicting
Limited Mode).
Chapter 10 Two Color.fm Page 85 Tuesday, June 7, 2005 1:17 PM