Dish Network 942 - Manual (Page 97)

Chapter 10
90
The Recover Button
T
HE
R
ECOVER
B
UTTON
Use RECOVER if you accidentally change the channel or video input on your TV and
cannot get the picture back from your satellite receiver. When you press RECOVER as
described below, the remote control sends commands to your TV to change channels or
video inputs to get back to watching satellite programming. This procedure works only if
you have accidentally changed the TV channel or video input. It does not recover lost
satellite signal (See Troubleshooting on page 124 for information on solving problems).
Note: The remote must be programmed to control the TV (and VCR, if applicable) for
RECOVER to work as described.
Note: RECOVER will first try to tune your TV to channel 3, then channel 4, and then other
video inputs with each press of RECOVER. You may need to press RECOVER up to 30
times to recover your satellite TV video. If RECOVER is programmed to a specific channel
(see page 91), RECOVER will tune the TV to the specific channel (for example, channel
60).
Button Used With Description
1
TV, VCR
Press RECOVER if you accidentally change the channel or
input on your TV or VCR (see page 91 to program and use
RECOVER).
2
TV
Press FORMAT/* to change the aspect ratio of the HDTV
screen. Press the button repeatedly to cycle through all of the
available aspect ratios. See your user’s guide that came with
your HDTV.
3
Number TV, VCR
Use the NUMBER PAD to change the channel or to select a
menu option.
Chapter 10 Two Color.fm Page 90 Tuesday, June 7, 2005 1:17 PM