Dish Network 942 - Manual (Page 103)

Chapter 11
96
Using Shared View
U
SING
S
HARED
V
IEW
Shared View is a feature of Single Mode that lets you activate the TV2 audio and video
outputs to display the same programming as the TV1 outputs. While using this feature,
both the Remote Control 1 and Remote Control 2 for your satellite receiver can control
what is displayed on all TVs connected to the system. This feature is available only in
Single Mode.
1
Make sure the receiver is in Single Mode as described on page 15.
Note: Make sure you are using Remote Control 1 and TV1 because you cannot enable or
disable this feature using Remote Control 2.
2
Press MENU, select System Setup (6), and then select Shared View (2) to open the
Shared View screen.
3
Select Enable View or Disable View.
Note: If you do not want to display programming on any other TV besides TV1 and you do
not want Remote Control 2 to control the receiver, select Disable View. After you select
Done, TV2 will show a screen that says Shared View is currently disabled.
4
Select Done.
U
SING
C
ALLER
ID
Caller ID displays on your TV the names of people and/or telephone numbers as they call
you if you subscribe to Caller ID from your local phone company. To use this feature, make
sure you have a phone line connected to the receiver and that the Caller ID feature is
enabled.
Chapter 11 Two Color.fm Page 96 Tuesday, June 7, 2005 1:20 PM