Dish Network 942 - Manual (Page 99)

Chapter 10
92
The Recover Button
1
Make sure the TV is on.
2
Press and hold RECOVER until all four mode buttons light, and then let go of the button.
The SAT mode button flashes twice and then all four mode buttons flash three times.
3
Press RECOVER. Wait for the TV or VCR mode button to flash once and then all four
mode buttons to flash once.
4
If you see the System Info screen, press SELECT to close the screen. You have recov-
ered your satellite video.
5
If you do not see the System Info screen, repeat steps 2 and 3 until you have recovered
your satellite video.
Note: Press any remote control button other than RECOVER to end this procedure.
Note: If RECOVER is not programmed to a specific channel, RECOVER will first try to
tune your TV to channel 3, then channel 4, and then other video inputs with each press of
RECOVER. You may need to press RECOVER up to 30 times to recover your satellite TV
video. If RECOVER is programmed to a specific channel (see page 91), RECOVER will
tune the TV to the specific channel (for example, channel 60).
Chapter 10 Two Color.fm Page 92 Tuesday, June 7, 2005 1:17 PM