Dish Network 942 - Manual (Page 35)

Chapter 2
28
Tips
T
IPS
• You can use the Front Panel Locks to prevent the mode from being changed
accidentally. See page 53 for instructions.
• The only way to turn off the TV2 outputs is by using POWER on Remote
Control 2.
• In Dual Mode, Remote Control 1 is used to control TV1 menus on the nearby HDTV.
Remote Control 2 is used to control TV2 menus on the remote TV(s).
• If you do not do anything in a menu for several minutes, the menu automatically
closes. This will discard any changes you made, and display the program you were
watching.
• To use Remote Control 2, be sure to attach the UHF Remote Antenna. See page 17
for details.
• On Remote Control 2, press FORMAT/* to change the aspect ratio (display shape) of
HD channels displayed on remote TV(s).
Q
UESTIONS
• Why put the receiver in Single Mode? When the receiver is in Single Mode, you can
use the PIP functions.
• How can I watch and use the DVR functions on the same program on all of the
TVs in my house? Put the receiver in Single Mode (page 15) and then enable
Shared View (page 96).
Chapter 2 Two Color.fm Page 28 Tuesday, June 7, 2005 12:52 PM