Dish Network 942 - Manual (Page 94)

Remote Controls
87
Controlling Other Components
4
Press ZERO (0).
5
Press POUND (#). TV flashes three times.
6
Press SAT.
7
Press the plus (+) and minus (-) sides of VOLUME. The TV’s volume changes and TV
lights instead of AUX.
Programming to Control a Second Satellite Receiver
If you have another DISH Network satellite receiver installed, you can use this remote in
AUX mode to control it along with your new receiver. When you program the remote to
control this other receiver, the remote will send out IR and UHF (not UHF Pro) signals to
the receiver. You can program the remote to control any other DISH Network satellite
receiver, except for following:
• DISH 322 - TV2
• DISH Player-DVR 522 - TV2
• DishPlayer 7100/7200
1
Turn on the other receiver and display the System Info screen (see the user’s guide for
information on how to display the screen).
Write the address:
2
Press and hold AUX until all the other mode buttons light up, and then let go of the button.
AUX flashes.
3
Press the 3 button.
4
Use the NUMBER PAD to enter the address you wrote in step 1.
5
Press POUND (#). AUX blinks three times.
6
Press RECORD to make sure the address and the remote matches the address on the
receiver.
Chapter 10 Two Color.fm Page 87 Tuesday, June 7, 2005 1:17 PM