Dish Network 942 - Manual (Page 114)

Connections and Setup
107
Connecting to the Nearby HDTV (TV1)
YP
B
P
R
Connections
The YPbPr connections provide high-quality video to your HDTV or HD monitor.
1
Connect between the YPbPr component connections on the receiver and the nearby
HDTV using component video cables.
2
Connect audio (red and white) RCA-type cables between the receiver Audio Outputs and
audio input connections that go with the YPbPr connectors on your HDTV or monitor.
3
If you do not see a picture, change the resolution setting on the receiver.
4
Turn up the volume on your HDTV and confirm you have sound. Check the RCA-type
connections if you don’t have sound.
No Picture on the Nearby HDTV
This section will help you make a picture on the nearby HDTV in the event that you could
not do so in the previous sections.
1
Connect RCA-type cable connections between the receiver TV2 Out and the Nearby
HDTV.
2
Make sure the receiver and nearby HDTV are on.
3
Make sure the nearby HDTV is set to display TV2. Look on the back of your HDTV and
consult your HDTV user’s guide.
4
Make sure you have the remote control antenna attached as described on page 17.
5
On the receiver front panel, press SYS INFO
6
On Remote Control 2, press RECORD.
7
Change the HDTV settings as described on page 108.
8
Switch to the nearby HDTV to display TV1. If you have a picture from TV1, you are
finished.
9
Repeat steps 6 through 8 until the nearby HDTV displays video from the receiver.
Chapter 12 Two Color.fm Page 107 Tuesday, June 7, 2005 1:22 PM