Nortec ME Control - Manual (Page 32)

32 Operating the Nortec ME control software
– Hours of Operation: Operating hours since initial commissioning of the
system.
– Next ME Service: Remaining time until next maintenance of the system
must be performed.
– Next UV Bulb: Remaining time until the UV bulb of the optional UV device
must be replaced.
– Next PureFlo: Remaining time until the cartridge of the PureFlo Ag+ op-
tion must be replaced.
Maintenance
Evaporator Conditions
The content of the “Evaporator Conditions” information section depends on the set dilution mode.
Dilution mode set to “ Fill Cycle”:
– Dillution Fill cycle: Actual set fill cycles for periodical tank draining de-
pending on the fill cycles.
– Drain Interval: Actual set tank drain interval time.
Dilution mode set to “ Dilution µS Limit”:
– Conductivity: Actual conductivity of the water in the tank in µS (µS/cm).
– Water Temperature: Actual temperature of the water in the tank in °C
or °F.
– Dillution µS Limit: Actual set conductivity limit value if exceeded a dilution
cycle is triggered.
– Drain Interval: Actual set tank drain interval time.
Dilution mode set to “ Dilution H2O Temp”:
– Water Temperature: Actual temperature of the water in the tank in °C
or °F.
– Dilution H2O Temp: Actual set temperature limit value Actual temperature
of the water in the tank in °C or °F if exceeded a dilution cycle is triggered.
– Drain Interval: Actual set tank drain interval time.
Dilution mode set to “ Dilution Interval”:
– Dillution Interval: Actual set dilution interval time, for periodic dilution of
the water in the tank.
– Drain Interval: Actual set tank drain interval time.