Nortec ME Control - Manual (Page 47)

47 Operating the Nortec ME control software
5.5.2.2 Output diagnostic functions – “Output Diagnostics” submenu
CAUTION!
The operation of the “Output Diagnostics” submenu requires wide knowledge of the control software
and must be operated only by authorised and trained personnel, since false operation may lead to
damage of system components.
The following diagnostic functions are available after accessing the “Output Diagnostics” submenu.
Hydraulic
– Inlet Valve: with this function you can open and close the inlet solenoid
valve.
– Drain Valve: with this function you can open and close the gravity drain
solenoid valve.
– Drain Pump: with this function you can start and stop the drain pump.
– Stage Pump 1: with this function you can set the speed of stage pump 1
in % of the maximum revolution speed.
– Stage Pump 2: with this function you can set the speed of stage pump 2
in % of the maximum revolution speed.
– Stage Pump 3: with this function you can set the speed of stage pump 3
in % of the maximum revolution speed.
– Stage Pump 4: with this function you can set the speed of stage pump 4
in % of the maximum revolution speed.
– Stage Pump 5: with this function you can set the speed of stage pump 5
in % of the maximum revolution speed.
– Stage Pump 6: with this function you can set the speed of stage pump 6
in % of the maximum revolution speed.
Note: only Nortec ME XL systems have pump 6.
– Stage Pump 7: with this function you can set the speed of stage pump 7
in % of the maximum revolution speed.
Note: only Nortec ME XL systems may have pump 7.