Nortec ME Control - Manual (Page 62)

62 Fault elimination
7 Fault elimination
7.1 Fault indication on Nortec ME Control control unit
Malfunctions during operation detected by the control software are indicated by a corresponding Warn-
ing message (operation still possible) or Fault message (operation not longer possible) in the operating
status field in the standard display of the control unit:
Warning
Temporary problems (e.g. water supply interrupted for a short time) or mal-
functions which cannot cause damage to the system are indicated with a
warning message. If the cause of the malfunction disappears of its own accord
within a certain period of time, the alarm message will automatically switch
off otherwise an fault message is triggered.
Note: If warning indication has been switched off in the configuration menu,
malfunctions with warning character will not be indicated by the optional remote
operating and fault indication.
Fault
Malfunctions where further operation is not possible any longer or malfunctions
which can damage the system are indicated with a fault message, addition-
ally the red LED below the touch panel light up. If such a malfunction occurs
the operation of the system is limited only or the system will be switched off
automatically.
By pressing on the maintenance and malfunction indication field in the standard operating display the
error list shown with all active warning and fault messages. By pressing on the corresponding Warning or
Fault entry additional information regarding the malfunction are displayed (see display on the far-right).