Thinklogical X4 Configurator Manual - Manual (Page 25)

X4 Configurator Manual 25 October, 2012
Select one of the older sources from router A and then a destination on router B. For this example we’ll
use Src 3 and destination Dst B2.
Note that there is no obvious indication that the connection required tie lines. But if you select the
ADMIN link and the Tie Lines tab, you will see the tie line in action.
This page shows that the source, “Src 3”, is entering router “A” and output through the tie line named
AB-1 to enter router “B” and finally being sent to destination “Dst B2”.