Verilink 2000 (34-00182) Product Manual - Manual (Page 8)

1-4 G ENERAL
Environmental Operating Temp: 0
°
to 50
°
C (32
°
to 122
°
F)
Storage Temp: -20
°
to 85
°
C (-4
°
to 185
°
F)
Humidity: 95% max (non-condensing)
Compatibility TR54016
TR62411
ANSI T1.403
Industry
Listings
FCC Compliance: Part 15 Subpart B, Class A
FCC Part 68 Reg. #: FXKUSA -74451-DE -N
UL Approved E110448
CSA Certified: LR98859
DOC /CSO3: 1653 5188 A
Battery-backed
RAM
The unit’s configuration and operating parameters are stored in nonvolatile RAM
memory. In case of a power outage and if the DIP switches are set to boot from
RAM, the unit’s memory is checked during power up. If the RAM has been
compromised, the unit’s configuration reverts to the options set with the remaining
DIP switches.
FCC
Requirements
WARNING: Changes or modifications to this unit not expressly approved by the party
responsible for compliance could void the user’s authority to operate the equipment.
This device complies with Part 15 of the FCC rules. Operation is subject to the
following two conditions:
✦ This device may not cause harmful interference.
✦ This device must accept any interference received, including interference that may
cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class A
digital device, pursuant to Part 15 of FCC Rules. These limits are designed to
provide reasonable protection against harmful interference when the equipment is
operated in a commercial environment. This equipment generates, uses, and can
radiate radio frequency energy and if not installed and used in accordance with the
instruction manual, may cause harmful interference to radio communications.
Operation of this equipment in a residential area is likely to cause harmful
interference. The user will be required to correct the interference at his own
expense.
Shielded cables must be used with this unit to ensure compliance with the Class A
FCC limits.
Notice to Users of 1.544 Mbps Service: The following instructions are provided to
ensure compliance with FCC Rules, Part 68.
1 All direct connections to T1 lines must be made using standard plugs and jacks.
!