Verilink Red Zone Encryption (REMS) (880-502423-001) Product Manual - Manual (Page 61)

Red Zone Encryption Management System (REMS) User Manual 6-1
Chapter
6
Configuring and starting REMS
This chapter describes:
■
Configuring REMS using the thumbwheel switch interface
■
Interpreting the LED indicators
Configuring REMS using the thumbwheel switch
The operator uses the EXE (execute) and FUNCTION thumbwheel
switches on the NCC 2020 modules to configure REMS. There are
thumbwheel switches in both the FBR and the BRC. You must configure
the FBR and the BRC separately, as if they were two separate AS2000
nodes.
Figur e6-1, NCC Thumbwheel Switches shows the top section of the
master NCC 2020 front panel.