Verilink Red Zone Encryption (REMS) (880-502423-001) Product Manual - Manual (Page 62)

Configuring and starting REMS
6-2 Red Zone Encryption Management System (REMS) User Manual
CAUTION
Do not attempt to use AM2000 or ASCII Terminal Interface (ATI) to
configure REMS. (There are some exceptions, which are noted.) Use
only the thumbwheel interface. If you accidentally change
configuration using the AM2000 or the ATI, reconfigure the system
using the thumbwheel interface. Do not use other thumbwheel
commands that you may find in AS2000 manuals. Unspecified results
may ensue.
Figure 6-1 NCC Thumbwheel Switches
Using the
thumbwheel
switches
(overview) The system must be powered up before you use the thumbwheel switch
interface. The thumbwheel switch interface is enabled by default. You can
log into Access Manager 2000 (AM2000) to verify that the thumbwheel
switches are enabled.
Before entering thumbwheel commands, you must address the
appropriate FBR or BRC NCC 2020 by entering its slot address number
into the thumbwheel switches. Slot addresses numbers are two-digit
numbers that range from 01 to 30. The NCC is typically in slot 01.
Configuring the system using the thumbwheel switches is a two-step
process. The operator enters a command by setting the FUNCTION
thumbwheel switches to the corresponding command number (address).
The operator then presses the EXE button twice (in one second).
!
NCC
2020
EXE
X
X
First digit o
command.
(TENs Value)
Push the buttons on
this side to decrement
the digit values. Push the buttons on
this side to increment
the digit values.
Second digit of
command.
(ONEs Value)
Press this button twice
within 1 second to
execute the command.
F
UNCT
ION