DCS 500 - Manual (Page 40)

Chapter 3 - Handling of Control Panel CDP 31x
IV A
3 - 4 DCS 500B / DCP 500B Operating Instructions
Parameter Mode
PAR
The Parameter Mode is used for:
-
change the structure in the firmware
- show signals and their actual status
- show and change values of parameters, if they are not
write-protected.
When the Parameter mode is entered parameter 101 appears after
initialization, otherwise the selected parameter is shown.
0 L 0.0 rpm 00
17 RAMP GENERATOR
01 RAMP.[IN]
119.03
Parameter and Signal Display
Statusrow
Group number
and name
Subgroup number
and name
Parameter value or
connection to or
status
All function blocks are characterised by inputs and outputs with
numbers. These inputs and outputs can be subdivided into two
categories:
• Pins for designating connections
• Parameters for setting values, such as ramp-up / ramp-
down time, controller´s gain, reference values, etc.
If a write-protected pin or parameter is selected, the following warn-
ing will be displayed.
**WARNING**
WRITE ACCESS DENIED
PARAMETER SETTING
NOT POSSIBLE
Function Mode
FUNC
The Function mode is used for special functions, such as:
•
Parameter UPLOAD from drive to CDP 31x
•
Parameter DOWNLOAD from CDP 31x to drive
•
CDP 31x display contrast setting
0 L 0.0 rpm 00
UPLOAD <=<=
DOWNLOAD =>=>
CONTRAST 7 Statusrow
Selectable
Functions
Display contrast
adjusting
_
Function Display
3ADW000055R0401_DCS500B_Operating Instruction_e_d