Watson-Marlow SPS User Manual
Page 72
MasoSine SPS sinusoidal pumps User Manual
72
Pumps with a stainless steel power frame: assembling the pump
housing
l Fit the flush ring. Whichever flush ring is installed, the procedure is the
same. For single mechanical seal system the distance ring is not needed.
l Position the pump housing carefully.
Note: the pump housing is heavy.
l Use a 13mm spanner to fit and tighten the six screws (right-hand
thread) and washers which secure the pump housing to the power
frame.
SPS 200 pumps
with a single
mechanical seal
Note: See page 64 for assembling the pump housing of a pump with a cast iron
power frame.
SPS 200 pumps
with a triple lip
seal
Pumps with a stainless steel power frame and a triple lip seal:
assembling the distance ring
l Fit the distance ring into the flush ring before fitting the flush ring.