23 the static flushing device – Watson-Marlow SPS User Manual
Page 96
Advertising
MasoSine SPS sinusoidal pumps User Manual
96
23 The static flushing device
SPS 100
SPS 100 pumps
Fitting the static flushing device
l The static flushing device can be fitted only to a SPS 100 pump with a pump
seal housing which is tapped to take it (arrowed). See also 22.2.2 Assembling
the SPS 100.
l Pass the special L-shaped tool or a screwdriver through the top hole in the
bearing housing and use it to rotate the pump seal housing until it is central to
the top hole in the bearing housing.
l Fit the sight glass connection piece. Use a 17mm spanner to tighten it.
l Fit the sight glass.
The sight glass and the sight glass
connection piece
The tapped pump seal housing
Advertising