Watson-Marlow SPS User Manual
Page 78
Advertising
![background image](/files/809045/content/doc078.png)
MasoSine SPS sinusoidal pumps User Manual
78
l Check that the front cover O-ring (arrowed on previous page) is in its groove in
the front cover.
l Fit the front cover, complete with the front support, over the shaft and the
pump housing studs.
l Fit the cap nuts (right-hand thread) and washers to the pump housing studs.
Use a 22mm spanner. Tighten them to 35Nm.
Fitting the front cover
SPS 200 pumps
Advertising